1 When the red wire is connected to the positive pole of the power supply “+”, and the black and blue wire connected to the negative pole of the power supply “-” , the motor’s rotation direction is CCW, viewed from the output shaft side .

2 When the red wire is connected to the positive pole of the power supply “+”, and the black , blue and yellow wire connected to the negative pole of the power supply “-” , the motor’s rotation direction is CW, viewed from the output shaft side .

3 When the blue wire is connected to “-” , the motor runs at full-speed. When the blue wire is connected to the PWM signal , the motor speed can be adjusted .

4 The cable connection method of the motor must comply with the above instructions,. Reverse connection of the positive and negative of the power is strictly forbidden. Do not connect the motor to voltage higher than 26VDC.

5 When connect the terminal with the motor connector, the terminal should be aligned accurately and inserted slowly. Forced Press-In is forbidden. When separate the teminal from the motor , do not pull the lead wires by force to avoid possible damages to the motor connector.